Ref.	BEND	WIDTH	RISE	PULLBACK	CENTER	CHROME	BLACK
a	Clubman with knurling	27.5”	4.5"	6”	6.5"	Yes	yes
	clubman without knurling	28"	4.5"	6"	6"	Yes
b	Drag Bar	28”	3.84”	0”	5.6”	yes	yes
c	Daytona	29.2"	5.36"	3"	4.4”	yes	yes
d	G.P. Touring	28”	4.2”	4.2”	4.8”	yes	yes
e	Superbike	29.2”	3.04”	3”	4”	yes	yes
f	European	30”	2.4”	4.8”	4.8”	yes	yes
g	LTD	30”	4.8”	7.2”	4.8”	yes	yes
h	Nighthawk	28”	7”	9.2”	4.8”	yes	yes

All bars are 7/8” OD (outside diameter)

Rise = how high the bars are from top to bottom

Width = end to end measurement

 Pull Back = how far bars come back toward rider

Center = length of center between first bends

When you measure the bar, first setup a table meets the wall, then put the bar on the table and rotate forward until the front of the bar is touching the wall. Rise is the distance from the bottom of the bar to the highest point (not the bent of the handlebar, pls see the difference between pic 1 and pic 3. In pic 1, the end of the handlebar is higher than the bent, so the rise is measured from the bottom of the bar to the end of the bar; in pic 3, the bent of the handlebar is the highest point of the bar, so the rise is from the bottom of the bar to the bent), pullback is measured from the wall to the farthest point back.

Go Back